.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
configure time based ACL
Hi,
If you look closely, you have applied the no-www to the ACL; It is showing as active on the time-range and active on the ACL. That is correct. I think you are looking at the worktime Time-range; which is “inactive”. You haven’t applied worktime to any of the ACL entries.
Best Regards
Khawar Butt CCIE#12353 (R/S , Security , SP , Voice) Http://www.khawarb.com Http://www.netmetric-solutions.com E-mail : khawarb@khawarb.com
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of ccie Sent: Monday, June 16, 2008 12:56 PM To: ccielab@groupstudy.com Subject: configure time based ACL
I experts,
I configure a time based ACL, then change the clock of the router to be outside this range. The time range show me it is inactive, while the time based ACE show me it is a active!!!!!!!!!!!
R5#sho time-range
time-range entry: no-www (active)
used in: IP ACL entry
time-range entry: worktime (inactive)
periodic weekdays 8:00 to 18:00
R5#sho access-list
Extended IP access list no-www
10 deny tcp 3.3.56.0 0.0.0.255 any eq www time-range no-www (active)
20 permit ip any any
Regards,
Amin
