Go CCIE Go!! - A Cisco Certified Internetwork Expert

What do you mean no holdtime. How do you know if a neighbor is dead?
sh ip eigrp int detail Will display the hello timer, default 5 seconds.
It is configured on a per interface basis: conf t int X ip hold-time eigrp ip hello-interval eigrp end wr
– http://dcp.dcptech.com
> —–Original Message—– > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > Behalf Of Gopalan Rajkumar > Sent: Wednesday, January 30, 2008 2:02 AM > To: John; ccielab@groupstudy.com > Subject: RE: EIGRP hold time > > EIGRP don’t have any holdtime..Read this. > > Why EIGRP doesn’t need timers ? > Maintaining a Topology Table allows a router to make sure that all its > own metrics to destination networks are larger than its neighbours, > thereby avoiding routing loops. EIGRP therefore does not need > Hold Down > or Flush timers since loops are avoided anyway. > > > > Regards, > Gopalan Rajkumar > Emirates Group IT > Phone : +971-4-2185161 > > > —–Original Message—– > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On > Behalf Of > John > Sent: 29 January 2008 21:50 > To: ccielab@groupstudy.com > Subject: EIGRP hold time > > Is there a way to show what the eigrp holdtime and hello interval are? > > I cant’t find it in the docs > > JG > > ______________________________________________________________ > _________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html > > ______________________________________________________________ > _________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html