Go CCIE Go!! - A Cisco Certified Internetwork Expert

Hi Max, AFAI see, you have wrong DLCI nubers at both side, you need to reverse the DLCIs at both end. And also you need to give a different hostname to one of the routers. eg.: Router1, Router2 etc.
Do a debug ppp authentication at one of the router, you will see output like below; *Mar 1 00:12:36.343: Vi2 AUTH: Timeout 5 *Mar 1 00:12:36.343: Vi2 CHAP: O CHALLENGE id 32 len 25 from “what” *Mar 1 00:12:36.343: Vi2 CHAP: I CHALLENGE id 32 len 25 from “what” *Mar 1 00:12:36.343: Vi2 CHAP: Ignoring Challenge with local name
—–Original Message—– From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Max Bozeman Sent: Saturday, August 26, 2006 8:47 AM To: ccielab@groupstudy.com Subject: PPPoFR $%#&^%!! - What am I missing?
Setup:
R1R2
config:
R1# interface Serial0/0 no ip address encapsulation frame-relay IETF shutdown no fair-queue frame-relay interface-dlci 201 ppp Virtual-Template1 no frame-relay inverse-arp frame-relay lmi-type ansi ! interface Virtual-Template1 ip address 1.1.1.1 255.255.255.0 ppp authentication chap ppp chap hostname what ppp chap password 0 theheck
R2# interface Serial0/0 no ip address encapsulation frame-relay IETF shutdown frame-relay interface-dlci 102 ppp Virtual-Template1 no frame-relay inverse-arp frame-relay lmi-type ansi ! interface Virtual-Template1 ip address 1.1.1.2 255.255.255.0 ppp authentication chap ppp chap hostname what ppp chap password 0 theheck
alt config:
R1# interface Serial0/0 no ip address encapsulation frame-relay IETF no frame-relay inverse-arp frame-relay lmi-type ansi ! interface Serial0/0.1 point-to-point frame-relay interface-dlci 102 ppp Virtual-Template1 ! interface Virtual-Template1 ip address 1.1.1.1 255.255.255.0 ppp authentication chap ppp chap hostname what ppp chap password 0 theheck
R2# interface Serial0/0 no ip address encapsulation frame-relay IETF no fair-queue no frame-relay inverse-arp frame-relay lmi-type ansi ! interface Serial0/0.1 point-to-point frame-relay interface-dlci 201 ppp Virtual-Template1 ! interface Virtual-Template1 ip address 1.1.1.2 255.255.255.0 ppp authentication chap ppp chap hostname what ppp chap password 0 theheck
Virtual-Access 1 is up, but cannot ping local or remote address. Doesn’t show up in ip int brief and does not put a route in routing table. What am I missing? Is this a PPP/PPPoFR issue or a Virtual-Template/Access issue?

_______________________________________________ Join Excite! - http://www.excite.com The most personalized portal on the Web!