.jpg "Opportunities, Appliacation, Openings"){kind=small}
.jpg "Hand Job, Blow Job, Job Search, Monster Job"){kind=small}
.jpg "pusat resume, daftar kerja, cari kerja"){kind=small}
.jpg "Project Manager, SOftware Engineer, SAP Consultant"){kind=small}
Redistribution
thanks ; found out is dyna problem
Date: Fri, 23 May 2008 07:27:36 -0400From: again.tl@gmail.comTo: juvenn@hotmail.comSubject: Re: RedistributionCC: ccielab@groupstudy.com Hi Raul, If your route-map connected->ospf only permit interface fa0/1, then is your configuration problem. You need to permit interface fa0/1 and all interfaces in EIGRP. Lei On Thu, May 22, 2008 at 10:18 PM, raul raul wrote: Question to ask : |—–fa0/1 |—vlan 4—SW1——–fa0/0–R4—–Serial1/0——–s1/0—-R1 why when i redistribute connected on R4:fa0/1 into ospf ;after the redistribution conncetd on R4 i am not able to see the route of int fa0/0 R4 on R1 ;y is this so ?there is a mutual redistribute between eigrp and ospfis it my configuration problem ?let say R4router ospf 1network 1.1.121.4 0.0.0.0redistribute connected subnets route-map connected->ospfredistribute eigrp 1 subnetsrouter eigrp 11.1.x.x
